Saturator
This module algorithmically simulates the effect of warm diode clipping saturation.
References
Saturator module activation button:
Original vs. processed signal representation screen:
Grey line representing the original signal and the white line representing the processed signal. Dragging up-down adjusts the saturation current level, and left-right adjusts terminal voltage and emission coefficient parameters.
Saturation effect settings sliders panel:
Note: The effect algorithmically mimics a diode limiter.
Terminal voltage level:
range from 0.01 to 0.026 Volts
Emission coefficient slider:
range from 1 to 2
Saturation current level slider:
range from 0 to 100
Dry-wet signal ratio slider:
range from 0% to 100%
Guides
How to adjust the Saturator parameters?

  1. Drag "dry/wet" slider to control the effect's intensity on the signal.
  2. Drag up or down by screen to adjust the current level.
  3. Drag left or right by screen to adjust the terminal voltage level and emission coefficient.
  4. Manually fine-tune each parameter using the sliders: "voltage," "emission" and "saturation."